52x65 Commercial Grade Metal Building STEEL Heavy Industrial Equipment Cover

52x65 Commercial Grade Metal Building STEEL Heavy Industrial Equipment Cover. WELCOME TO EAST COAST HOMES. We are authorized dealers in the steel building industry and offer top of the line steel structures including car-ports, garages, RV covers, barns, storage buildings, commercial buildings, agricultural buildings, etc. Our steel structures can be designed to fit most any need that you might have.

All of the buildings that we sell are exceptionally manufactured from quality components ins of up to 80' wide and as long as you may possibly need. We are partnered with 7 of the top manufacturers in the steel building industry making us nationwide dealers. Commercial Grade 52x65 Metal Building Wide Clear Certified STEEL Structure. This listing is for a 52' wide x 65' deep/long x 20' tall c. Ommercial grade steel clear wide building.

A-Frame vertical roof with vertical side panels from top to bottom. This building is fully braced and engineered certified to meet local code including snow load and wind requirements. Building is engineered certified at 140 MPH winds and 35 PSF snow loads to meet code as well as priced for states shown below. In all states and can be priced and certified to meet code in all states. That we're with does it differently so all depends on your location and which.

Drawings needed for obtaining permit. If you're not planning on getting a permit is no problem at all. Building is priced with 14G steel ladder leg frame and 29 gauge steel vertical panels.

Concrete wedge anchors and ground anchors are both included in price for states listed below. Available in all states however this building is priced and designed to meet IBC code requirements specifically for the following states. VA, NC, SC, GA, TX & parts of AL, KY, TN.

Please call if you would like priced for your state! PRICES VARY FROM STATE TO STATE BC WIND & SNOW LOADS VARY. OUR BUILDINGS ARE PRICED & DESIGNED TO MEET LOCAL CODE IN YOUR STATE. WE USE MULTIPLE MANUFACTURERS W/ DIFFERENT PRICING TO COVER AS MANY STATES AS POSSIBLE. To Request Quote for ANY SIZE & ANY STYLE Building! 14 Gauge 2 1/2" x 2 1/2" (varies among manufacturers) Steel Frame/Tubing. Welded Center Braces on Every Roof Bow for Strength. Rebar Anchors for Ground Installation.

Concrete Bolts or Sleeve Anchors for Cement Installation. Horizontal Sides & End Panels. Engineered Certified Units up to 170MPH /65PSF Depending on state and building.... Stronger 26 Gauge Sheet Metal. 12 Gauge Framing Double Leg Option.

Vertical Side & End Panels. Web Welded Truss Designed Framing. Over-head Doors as Large as 14'x14. Additional Windows, Roll-Up Doors, Walk-In Doors, Panels, lean-to's, etc. Multiple Roof Styles- Regular, Boxed Eave or Vertical Style.

Interior Walls and/or Horse Stable Frame-ins. Windows and Doors that have a "Residential" Look. J Trim, L Trim and Corner Trim.

Site and Building Specific Engineered Sealed Drawings and Calcs. BUILDING SIZES OF UP TO 120' WIDE, 20' TALL AND AS LONG AS YOU COULD POSSIBLY NEED... Customer is required to rent/provide lift for all buildings over 14' tall. Built to Engineered Specifications to Meet Most Local Code Wind and Snow Load Requirements.

FL goes up to 170MPH. Snow Load Certification of up to 65PSF (Depending on State). Certified Anchoring Using Mobile Home Anchors (For Ground Install). Free Set of Engineered Drawings for Obtaining Permit. Drawings are generic sealed/stamped and cover a of sizes.

If your building does not fall within the sizes that they cover or if your city/county requires site and/or building specific plans, there will be an additional charge. INSTALLATION SURFACE & SLAB INFO. A concrete slab/pad is not required for most of our buildings (certain larger commercial buildings do require slab and/or permanent foundation) and we can install right on the ground.

The choice is yours to make and we will make sure to anchor properly depending on surface you choose to use. Other examples of installation surfaces include. Ground install with cement piers. When pouring a slab please not that frame size specified in ALL of our steel structure listings is actually 1 FOOT shorter than stated roof length due to 6 overhang on both sides.

In other words, if building is 18' wide x 21' long/depth, slab will need to be at least 18'x20'. Footers and depth requirements are typically determined by city/county code so please be sure to check with your local building dept. If you're not getting a permit, we can assist with suggested width and depth of footers.

We REQUIRE a Level Surface for Your Building Within 3"- 4". We can always adjust legs to be higher on one side/end if your surface is not level. If you plan on getting a permit than certification is required in order to meet the IBC code requirements. These drawings are generic sealed/stamped drawings and cover a of sizes.

If your building is not within the sizes they cover, then you will need a site/building specific set in which there will be an additional charge for. 100% FREE WITH ALL NON-COMMERCIAL SIZE BUILDINGS!! Setup can take a few hours depending on size, style and features so please keep that in mind when scheduling. WE REQUIRE A LEVEL SURFACE FOR YOUR BUILDING WITHIN. FAILURE TO DO SO CAN RESULT IN DELAY OF SETUP.

If we do not have listed the size or style of building (including features) that fits your needs, we would LOVE to help design and price one that works for you! EACH PHOTO IS CHOSEN SPECIFICALLY TO REPRESENT SIZE, STYLE & FEATURES AS BUILDING LISTED. PHOTOS ARE TO SIMPLY GIVE BUYERS A GENERAL IDEA OF UNIT WE ARE OFFERING. Thank you so much for visiting East Coast Homes! We are here to help so if you have ANY questions at all, please don't hesitate to ask.

TO ORDER OR INQUIRE TODAY. We are genuine sellers offering a variety of items at quality prices.

We are authorized dealers in the mobile home, modular home, steel building and pre-fab wooden building industry. We HOLD A CLASS A CONTRACTORS LICENSE in the state of VA and run a family owned brick and mortar store, est.

1968, that is still going strong today. Our sales team also consists of genuine collectors and antique traders. If not directly from our manufacturers and distributors, we get our other items at antique stores, thrift shops, yard sales, estate sales, auctions, flea markets, etc.

Sometimes the photos alone tell it all so please examine them carefully! For our products that we sell as dealers, our description is what matters most so please be sure to read them thoroughly. So, whether you're interested in a custom made steel garage or a rare figurine made in China, you can find it here at East Coast Homes!

All of our items are packaged with care! As soon as we possibly can. May be more, may be less. We describe all of the items that we sell to the best of our ability. We take this very seriously and pride ourselves on having satisfied customers.

Other than a light cleaning or wipe down with a dry cloth, we do not make any alterations of any kind to our antique and collectible items. We do not make repairs and do not do any hard scrubbing/cleaning/polishing with harsh chemicals. We do this because it is our belief that most buyers would prefer to receive their item(s) in as original condition as possible. Our top priority is costumer service & satisfaction. You may also be interested in....

The item "52x65 Commercial Grade Metal Building STEEL Heavy Industrial Equipment Cover" is in sale since Wednesday, January 10, 2018. This item is in the category "Business & Industrial\Construction\Buildings, Modular & Pre-Fab".

The seller is "eastcoasthomes68" and is located in Suffolk, Virginia. This item can be shipped to United States.

Type: Industrial Warehouse
Bundle Listing: No
Metal Type: Steel
Country/Region of Manufacture: United States
Roof Type: Vertical A-frame
Model: Commercial Building
Country//Region of Manufacture: United States
Material: Metal
Metal: Steel
Building Style: Commercial Garage
Use: Farm Equipment cover
Grade: Commercial, Industrial